SECTION 4 - MACHINE OPERATION
4-4
– JLG Lift –
3121606
4.3
ENGINE OPERATION
NOTE:
Initial starting should always be performed
from the Ground Control station.
Starting Procedure
IF ENGINE FAILS TO START PROMPTLY, DO NOT CRANK FOR AN EXTENDED PERIOD.
SHOULD ENGINE FAIL TO START ONCE AGAIN, ALLOW STARTER TO “COOL OFF” FOR 2-3
MINUTES. IF ENGINE FAILS AFTER SEVERAL ATTEMPTS, REFER TO ENGINE MAINTE-
NANCE MANUAL.
NOTE:
After turning on ignition, operator must wait until
glow plug indicator light goes out before cranking
engine.
1.
Turn key of Platform/Ground Select switch to
Ground.
2.
Pull the Power/Emergency Stop switch to On.
3.
Push the Engine Start switch until engine
starts.
ALLOW ENGINE TO WARM-UP FOR A FEW MINUTES AT LOW SPEED BEFORE APPLYING
ANY LOAD.
4.
After engine has had sufficient time to warm
up, push in the Power/Emergency Stop switch
and shut engine off.
5.
Turn Platform/Ground Select switch to Plat-
form.
6.
From Platform, pull Power/Emergency Stop
switch out.
To
order go
to
Discount-Equipment.com
