SECTION 4 - MACHINE OPERATION
4-14
– JLG Lift –
3121606
Telescoping the Main Boom
To extend or retract the main boom, use the Main
Telescope Control Switch to select In or Out move-
ment.
4.8
SHUT DOWN AND PARK
1.
Drive machine to a protected area.
2.
Assure main boom is fully retracted and lowered over rear of
the machine; all access panels and doors closed and secured.
3.
Remove all load and allow engine to operate 3-5 minutes at
Low setting to permit reduction of engine internal tempera-
tures.
4.
At Ground Controls, turn Key Select switch to (center) Off
position. Position Power/Emergency Stop switch (down) to
Off position. Remove key.
5.
Cover Platform Control console to protect instruction plac-
ards, warning decals and operating controls from hostile
environment.
4.9
MACHINE SAFETY SYSTEM OVERRIDE (MSSO)(CE
ONLY)
The Machine Safety System Override (MSSO) is
used to override function controls for Emergency
Platform Retrieval only. Refer to Section 5.4,
Machine Safety System Override (MSSO)(CE Only)
for operating procedures.
To
order go
to
Discount-Equipment.com
