SECTION 5 - EMERGENCY PROCEDURES
5-2
– JLG Lift –
3121606
5.3
EMERGENCY OPERATION
Operator Unable to Control Machine
IF THE PLATFORM OPERATOR IS PINNED, TRAPPED OR UNABLE TO
OPERATE OR CONTROL MACHINE:
1.
Other personnel should operate the machine from ground
controls only as required.
2.
Other qualified personnel on the platform may use the plat-
form controls. DO NOT CONTINUE OPERATION IF CONTROLS
DO NOT FUNCTION PROPERLY.
3.
Cranes, forklift trucks or other equipment can be used to
remove platform occupants and stabilize motion of the
machine.
Platform or Boom Caught Overhead
If the platform or boom becomes jammed or snagged in over-
head structures or equipment, rescue platform occupants prior to
freeing the machine.
5.4
MACHINE SAFETY SYSTEM OVERRIDE (MSSO)(CE
ONLY)
The Machine Safety System Override (MSSO) is
only to be used to retrieve an operator that is
pinned, trapped, or unable to operate the
machine and function controls are locked out
from the platform due to a platform overload sit-
uation.
NOTE:
If the MSSO functionality is used, the fault indicator will flash
and a fault code is set in the JLG Control System which must be
reset by a qualified JLG Service Technician.
NOTE:
No functional checks of the MSSO system are necessary. The JLG
Control system will set a Diagnostic Trouble Code if the control
switch is faulty.
To operate the MSSO:
1.
From the ground control console, place the Platform/
Ground Select switch in the Ground position.
2.
Pull out the Power/Emergency Stop control.
3.
Start the engine.
4.
Press and hold the MSSO switch and the control switch for
the desired function.
To
order go
to
Discount-Equipment.com
