SECTION 3 - MACHINE CONTROLS, INDICATORS, AND OPERATION
31217156
3-11
10. Leveling Jacks
(If Equipped)
- To engage Leveling Jacks,
select the Lift function on the three-position switch. Set and
Retract LEDs will illuminate on the indicator pad when the
control handle engages Set or Retract functions.
Moving the control handle forward (black arrow direction)
will lower the leveling jacks. Moving the control handle
backward (white arrow direction) will raise the leveling jacks.
Once the machine is level the jacks will discontinue extend
-
ing and the jack LED will stop blinking and stay lit.
Leveling Jacks Set -
This indicator light will blink
when the leveling jacks are being extended.
Leveling Jacks Retracting -
This indicator light will
blink when the leveling jacks are being retracted.
NOTE:
After initial ground contact is made, the auto
level function will pause 2-5 seconds and
then begin to properly level the machine.
NOTE:
There is an override feature on the Auto Level
-
ing system that allows the operator to adjust (trim) the level of
the machine to the left or right when the platform is completely
lowered. Use the following instructions to adjust the level of the
machine.
a.
With the leveling jack switch activated, squeeze the trigger
switch on the controller.
b.
To adjust the leveling jacks to the left, activate the switch
on top of the controller to the left. To adjust to the right,
activate the switch on top of the controller to the right. The
leveling jack indicator light for the side selected will be lit.
11. Two-Position Drive/Lift Select Switch
a. Drive Select Switch -
When selected,
the drive function will be active.
Depress the trigger switch and move
the control handle in the forward or
reverse direction will cause drive
motion to occur at a speed determined
by the range selected by the speed
switch and the distance the controller is moved from cen
-
ter.
b. Lift Select -
When selected, the lift/
lower function will be active. Depress
the trigger switch and move the con
-
trol handle in the forward or reverse
direction will cause platform motion to
occur at a speed determined by the
distance the controller is moved from
center.
In addition to normal operation, manual descent allows lift
down with power on and engine off.
DO NOT LOWER WITHOUT COMPLETELY RETRACTING THE PLATFORM EXTENSION(S).
To
order go
to
Discount-Equipment.com
