SECTION 3 - MACHINE CONTROLS, INDICATORS, AND OPERATION
3-12
31217156
12. Emergency Stop Switch -
A two-position,
red, mushroom-shaped emergency stop
switch functions to provide power to the
platform control station and also to turn off
power to the platform function controls in
the event of an emergency. With the power
select switch positioned to platform, power is turned on by
pulling the switch out (on), and is turned off by pushing the
switch in (off).
NOTICE
ALWAYS POSITION EMERGENCY STOP SWITCH TO "OFF" POSITION (PUSHED IN) WHEN
MACHINE IS NOT IN USE.
13. Glow Plug Switch -
(Diesel Engine Only)
A
momentary contact, push button type
switch that supplies electrical power to
the engine’s glow plugs to assist cold
starting. Once pressed, glow plugs are
active for 20 seconds. Allow the glow
plugs a few seconds to heat up before
starting the engine within the time frame.
14. Gasoline Fuel Select -
In this position the
switch is set up to change from propane
to gasoline on a machine equipped with
the dual fuel option.
15. Propane Fuel Select -
In this position the
switch is set up to change from gasoline
to propane on a machine equipped with
the dual fuel option.
16. Drive Speed Switch -
With
the platform lowered, the
three position drive speed
switch permits the operator to
select either high speed (3.5
mph - 5.6 kph), mid speed (2.0
mph - 3.21 kph), or low speed
(1.0 mph - 1.61 kph). All three
drive speeds use high engine
speed.
When platform is elevated above high drive cutout height,
drive speed is reduced to (0.5 mph) regardless of Drive
Speed Switch setting.
DO NOT USE HIGH RANGE WHEN DRIVING IN CLOSE QUARTERS OR WHEN DRIVING IN
REVERSE.
NOTE:
High/mid/low drive speeds are disabled when the platform is
raised above the high drive cutout height (refer to Section 2).
When platform is lowered below high drive cutout height, high/
mid/low drive speeds are enabled.
DO NOT OPERATE MACHINE IF HIGH DRIVE SPEED OPERATES WHEN PLATFORM IS
RAISED ABOVE THE HIGH DRIVE CUTOUT HEIGHT.
To
order
go
to
Discount-Equipment.com
