SECTION 3 - MACHINE CONTROLS, INDICATORS, AND OPERATION
3-20
31215932
ONLY FOLD DOWN THE RAILS WHEN THE MACHINE IS IN THE STOWED (PLATFORM
FULLY LOWERED) POSITION. DO NOT RAISE THE PLATFORM WITH THE RAILS FOLDED
DOWN. THE RAILS MUST BE IN THE UPRIGHT POSITION AND PROPERLY PINNED
WHEN RAISING THE PLATFORM.
1.
Remove the platform control box and place it on the plat
-
form deck.
2.
Remove two pins at the top front rails, then fold down the
front rail panel to the platform floor.
3.
Fold down inner extension rails to the platform floor.
Remove rail pin at top rear rail and fold in against the right
side top rail.
4.
Fold down outer platform rails towards platform floor.
To raise the rails back to the upright position, unfold the rails in the
reverse sequence they were folded and replace the rail pins into the
rails.
NOTE:
When setting platform side rails back to upright position be cer
-
tain the extension platform rail guide is interlocked with the
main platform rail once both rails are completely upright.
AFTER THE RAILS HAVE BEEN FOLDED DOWN, USE EXTREME CAUTION WHEN EXITING
AND ENTERING THE PLATFORM. ENTER AND EXIT PLATFORM ONLY AT THE GATE AREA
AND LADDER PROVIDED.
IF DRIVING MACHINE WITH THE PLATFORM CONTROL STATION FROM GROUND, DO
NOT HANG THE CONTROL BOX ON ANY PART OF THE MACHINE WHILE DRIVING. HOLD
THE CONTROL BOX AND KEEP AT LEAST 3 FT (1 M) DISTANCE FROM MACHINE.
Summary of Contents for JLG R2632
