SECTION 6 - SPECIFICATIONS AND OPERATOR MAINTENANCE
31215932
6-9
6.6 OPERATOR MAINTENANCE
Engaging the Safety Prop
NEVER WORK UNDER AN ELEVATED PLATFORM UNTIL IT HAS BEEN RESTRAINED FROM
MOVEMENT WITH THE SAFETY PROP, BLOCKING, OR OVERHEAD SLING.
THE SAFETY PROP MUST BE USED WHENEVER MAINTENANCE PERFORMED ON THE
MACHINE REQUIRES THE SCISSOR ARMS BE RAISED. ENSURE THERE IS NO LOAD IN THE
PLATFORM.
Before operator maintenance can be conducted, engage the
machine’s red safety prop. The safety prop is located at the rear of the
machine in the armstack.
To engage the safety prop:
1.
From the Ground Control Station, raise the platform approxi
-
mately 9 ft (2.7 m).
2.
At rear of machine, pull red safety prop into the vertical posi
-
tion.
3.
Lower the platform until the crossbar above the prop comes
into contact with the prop.
4.
Ensure all downward movement stops when safety prop is
engaged.
To disengage the safety prop:
1.
Raise the platform enough to release the safety prop.
2.
Push in the safety prop.
3.
Lower the platform to the stowed position.
Prop Disengaged
Prop Engaged
0"%
0"%
Summary of Contents for JLG R2632
