SECTION 3 – MACHINE CONTROLS, INDICATORS AND OPERATION
– JLG Lift –
3-41
E-0-2-5
Low AC voltage oscillation error
AC source is unstable. Could be caused by undersized generator and /or severely undersized
input cables. Connect charger to an AC source that provides stable AC between 85 - 270
VAC / 45-65 Hz. This error will automatically clear once the condition has been corrected.
E-0-2-7
USB overcurrent fault
USB hardware overcurrent protection has been tripped. Remove and reinsert USB flash
drive. If condition persists, try using a different USB flash drive.
E-0-2-8
Charge profile incompatibility
The selected charge profile is incompatible with the charger’s software. Update charger
software or select a different charge profile.
E-0-2-9
CAN Bus error
Check the physical CAN connector, electrical bus conditions and other CAN modules for cor
-
rect functioning (Comm configuration only).
E-0-3-0
Comm battery module error
Check the CAN bus battery module for correct functioning (Comm configuration only).
E-0-3-1
Internal charger error
Remove AC and battery for a minimum of 30 seconds and retry charger. If the problem per
-
sists, contact your Distributor / Product Support.
To
order
go
to
Discount-Equipment.com
