Section 1- General Safety Practices
1
-
4
31211368
Tip Over Hazard
General
• For additional load requirements, refer to the appropriate capacity chart.
• Never use an attachment without the appropriate original equipment manufacturer
(OEM) approved capacity chart installed on the telehandler.
• Understand how to properly use the capacity charts located in cab.
•
DO NOT
exceed rated lift capacity.
• Be sure that the ground conditions are able to support the machine.
• Be aware of wind conditions. Wind may cause load swing and dangerous side loads.
• Keep the machine a minimum of 2 ft (0,6 m) from holes, drop-offs, obstructions,
debris, concealed holes and other potential hazards at ground level.
•
DO NOT
raise boom unless frame is level (0 degrees), unless otherwise noted on
capacity chart.
•
DO NOT
level machine with boom/attachment above 4 ft (1,2 m).
(AUS -
DO NOT
level machine with load more than 11.8 in (300 mm) above
ground surface.)
OW0050
OW0080
OW0100
4 FT
(1,2 M)
https://www.forkliftpdfmanuals.com/
