SECTION 3 - MACHINE CONTROLS AND INDICATORS
3-26
31215066
6.
Tilt Warning Light and Alarm
This red illuminator indicates the chassis is on
a slope. If the boom is above horizontal and
the machine is on a slope, the tilt alarm warn
-
ing light will illuminate, an alarm will sound, available func
-
tions are placed in Creep speed, and drive is cut out in the
direction of travel. Drive in the opposite direction may be
allowed under certain conditions.
IF TILT WARNING LIGHT IS ILLUMINATED WHEN BOOM IS RAISED OR EXTENDED,
RETRACT AND LOWER TO BELOW HORIZONTAL THEN REPOSITION MACHINE SO THAT
IT IS WITHIN THE LIMITS OF THE MAXIMUM OPERATING SLOPE BEFORE EXTENDING
BOOM OR RAISING BOOM ABOVE HORIZONTAL.
NOTE:
When the tilt sensor alarm is activated the Drive function will be
disabled if the boom is elevated above horizontal.
7.
AC Generator Indicator
Indicates the generator is in operation.
8.
Creep Speed Indicator
When the Function Speed Control is turned to
the creep position, the indicator acts as a
reminder that all functions are set to the slow
-
est speed.
9.
Footswitch/Enable Indicator
To operate any function, the footswitch must
be depressed and the function selected within
seven seconds. The enable indicator shows
that the controls are enabled. If a function is not selected
within seven seconds, or if a seven second lapse between
ending one function and beginning the next function, the
enable light will go out and the footswitch must be released
and depressed again to enable the controls.
Releasing the footswitch removes power from all controls
and applies the drive brakes.
TO AVOID SERIOUS INJURY, DO NOT REMOVE, MODIFY OR DISABLE THE FOOTSWITCH
BY BLOCKING OR ANY OTHER MEANS.
Tilt Angle
Market
5°
All Markets
To
order go
to
Discount-Equipment.com
