10279-D01-00
Page 15 of 142
This information is the property of Oshkosh Specialty Vehicles and is considered to be confidential. The contents may not be used, either
partially or wholly, for any purpose inconsistent with which it was produced. This information may not be reproduced or disclosed without prior
express consent.
Section 2: Safety Guidelines
Use and follow the appropriate Lockout/Tagout procedures as required by
OSHA Standard 1910.147 when performing maintenance or servicing any
electrical, hydraulic or pneumatic systems. See Appendix E for Lockout/Tagout
procedures.
It is the operator’s responsibility to verify that the shore power receptacle is of
the same type and voltage as the connection that is supplied by Oshkosh
Specialty Vehicles. Failure to do this can result in injury or death to the
operator of the mobile unit as well as irreparable damage to the mobile unit.
Make sure that all electrical parts are serviced only by a certified electrician or
qualified personnel. Dangerous voltages are present which could result in
injury or death.
Always make sure that eyes are protected while servicing the unit. Wear safety
goggles when prying, drilling, grinding, or working with batteries. Wear safety
goggles over regular prescription glasses unless the lenses are made of
hardened glass and can serve as safety goggles.
Be certain to disconnect the power before working on any of the electrical
systems.
When servicing the unit be certain that a first aid kit and fire extinguisher are
within reach at all times.
This safety section contains important information in regards to general safety guidelines that
should be followed. Before attempting to service the mobile unit, read this safety section as well as
all other safety sections found in applicable manufacturers’ manuals in the component literature
binder.
2.1
General Safety Precautions
1. Make sure the work area is well ventilated.
2. Disconnect the electrical power to prevent the possibility of electrical shock when servicing
all electrical equipment.
3. Follow all manufacturers’ directions and request material data sheets where applicable.
4. Always keep tools clean and free of grease.
5. Do not stand on chairs inside of the mobile unit under any circumstances.
6. Follow all safety precautions found in the documentation package that is included with the
mobile unit.
