10279-D01-00
Page 64 of 142
This information is the property of Oshkosh Specialty Vehicles and is considered to be confidential. The contents may not be used, either
partially or wholly, for any purpose inconsistent with which it was produced. This information may not be reproduced or disclosed without prior
express consent.
6.13 Raise the Landing / Stabilizing Legs
After the tractor has successfully connected to the mobile unit, the stabilizing legs can be raised.
Refer to
Figure 49: Landing / Stabilizing Leg Assembly
for the following procedure.
1. Move and hold the pump switch in the “ON” position.
2. Push the levers away from you to retract the legs. This will lower the front end of the
mobile unit.
3. Retract the legs to their transport positions.
4. Release the pump switch. The pump switch should automatically retract to the “Pump
OFF” position.
6.14 Verify that the Mobile Unit is ready for Transport
Before the mobile unit can be transported, a final check of all components is necessary. Please
refer to the following when checking the mobile unit.
1. Have the chairs, monitors, doors, cabinets, cameras, and printers been secured? Is the
Scan Room door closed and locked? Make sure that all of these items have been secured
with the supplied hardware prior to transporting the mobile unit.
2. Are all exterior doors closed and locked? If not, make sure that all exterior doors are closed
and locked.
3. Is the Platform Lift in the transport position, fully seated in its retaining cradle? If not, make
sure that the Platform Lift is in the transport position, fully seated in the cradle, the
transport pins are inserted, and all micro switches are actuated and the Lift Transport
Restraining Cable is in place and securely connected.
4. Are all running & marker lights working correctly? If not, replace any LED lights that are not
working before transporting the mobile unit.
5. Are any warning lights illuminated? If so, check to find the cause of the warning. Do not
move the mobile unit if any warning lights are illuminated or strobe lights are flashing. If
further assistance is needed, refer to the Oshkosh Specialty Vehicles VOL II Vendor
Information binder for the product manual, the Oshkosh Specialty Vehicles VOL I
Service/Operation Manual binder for a list of local service representatives, or call Oshkosh
Specialty Vehicles for further assistance.
6. Is the fuel tank full? Check the fuel gauge, located in the underbody compartment, and fill
the fuel tank if necessary.
7. Verify that the air suspension system is fully inflated and at the proper ride height. The
lowest point of the trailer sidewall should be approximately 15” above ground level.
