3 - 14
Trumpcard Ethernet LAN
Section Three
Microsoft Workgroup Connection for DOS
To install Workgroup Connection for DOS, the Trumpcard driver diskette
contains the required files to allow the installer to import an OEM diskette.
1. Run SETUP from MSWGCN Workgroup Connection diskette.
2. When prompted to select a Network card, select
“Network card not shown on list below...”
3. When prompted for the location (path) of the OEM driver, insert the
Trumpcard driver diskette and enter A:\WFW\31
4. Press ENTER to select the highlighted entry: Ositech Trumpcard
5. Continue with the installation, if prompted to re-insert the OEM
driver diskette be sure to enter the location (path) A:\WFW\31 as
well.
The following are examples of changes made to the CONFIG.SYS,
AUTOEXEC.BAT and PROTOCOL.INI
CONFIG.SYS
DEVICE=C:\DOS\PROTMAN.DOS /I:C:\DOS
DEVICE=C:\DOS\WORKGRP.SYS
DEVICE=C:\DOS\OTCETH.DOS
AUTOEXEC.BAT
C:\DOS\NET START
PROTOCOL.INI
[Network.setup]
version=0x3110
netcard=ms$otceth$nic,1,MS$OTCETH$NIC
transport=ms$netbeui,MS$NETBEUI
lana0=ms$otceth$nic,1,ms$netbeui
[protman]
DriverName=PROTMAN$
PRIORITY=MS$NETBEUI
[MS$OTCETH$NIC]
DriverName=OTCETH$
MEM=0xc800
Interrupt=5
IOBase=0x300
Summary of Contents for 614006-001
