4 Usage
4.1 Introduction
•
At first, produce and dispense 5 litres of water which you then dispose of
by dispensing all the cold and hot water. This will flush out any loose filter
media. It is normal to see black water when using new filters.
• If there is water leakage from the machine, please disconnect the power
and contact the customer service centre. If there is any abnormal or
unexpected sound, smell, or smoke, etc., please disconnect the power and
contact the customer service centre.
4.2 Flushing
•
After the setup, the machine automatically enters the flushing state and
works for 120 seconds. In the flushing state, the filtering symbol of the
display interface light will be on (see Figure 2) .
4.3 Purification
•
After flushing, the machine automatically enters the filtering state. The
filtering symbol on the display interface light will be on (see Figure 2).
4.4 Replace Water
• The system will detect the source water quality in normal operation. If
the water level is lower than the set level, the user will be prompted to
replace the source water. You must empty the Supply Pitcher every time it
is refilled. The renew water symbol of the display interface
will light on at this time (see Figure 2).
IMPORTANT NOTE: You must empty
the Supply Pitcher before refilling it
with fresh water as this can block
your filters
