29
3
20Pin jumper
wire Male to
female 20cm
some
4
Hex
Screwdriver
1
5
M3 plastic
screw
18
6
M3 plastic
pillar
19
7
M3 plastic nut
19
Hardware Installation
Step 1:
Install the smart car basic frame work as per
you have already completed installation in Lesson 1 , just keep it as is.
Step 2:
Add an IR receiver module onto the car. Install the IR receiver module
with 2pcs M2.5*10 plastic screws, M2.5 plastic pillars and M2.5 plastic nuts at
the front of upper chassis.
Step 3:
Connect the S pin in IR receiver to D10 pin in UNO board, GND to
GND, VCC to 5V, as the following photo (
Remember: DO NOT remove any
Summary of Contents for V2.1
