47
Step 2:
Download Lesson 4 tracking smart car sample code
http://osoyoo.com/picture/V2.1_Arduino_Robot_Car/code/v2smartcar-
, unzip the download zip file smartcar-lesson4.zip, you will see a
folder called smartcar-lesson4.
Step 3:
Connect UNO R3 board to PC with USB cable, Open Arduino IDE ->
click file -> click Open -
> choose code “smartcar-lesson4.ino” in smartcar-
lesson4 folder, load the code into arduino.
Step 4:
Choose corresponding board/port for your project, upload the sketch
to the board.
Summary of Contents for V2.1
