52
9
M3 plastic pillar
1
10
M3 plastic nut
1
11
M2*4 self tapping
screw
1
12
M2.2*8 self
tapping screw
2
13
M1.4*8 screw and
nut
4
Hardware Installation
Step 1:
Install the smart car basic frame work as per
you have already completed installation in Lesson 1 ,
Everything keep it as is
except move ENA from D9 to D3(we need D9 for Servo control)
. If you have
installed Lesson 2 or 3, please remove the wires. If you have installed Lesson
4, please keep it.
Step 2:
Install servo motor at the front of upper car chassis with 2pcs M2.2*8
Self Tapping Screws
Summary of Contents for V2.1
