3
ZELION
®
HL300
Fixture Operation:
Once main power is turned ON, the ZELION HL300 will begin to
operate at Factory setting. For desired operating parameters, fi xture
power intensity and spectra can be adjusted using the Senmatic
HL300 Lighting Software Interface off ered by OSRAM.
Fixture Cleaning:
To clean, wipe fi xture with a soft cloth. Clean lenses with a mild soap
and rinse thoroughly with clean water and sponge.
DO NOT use abrasive materials, solvents, scouring pads, or abrasive
cleaning powders as doing so may scratch the fi xture fi nish.
Once per season remove end-cap and clean fan and inside sur-
faces using a soft brush to remove loose dust with brush or low
pressure air. Never clean with a water hose or liquid media or cleansers.
WARNING:
To avoid personal injury and/or possible product damage, the fol-
lowing cautions must be followed:
· To prevent electric shock, match wide blade of plug to wide slot.
· Caution – Risk of fi re. (i.e. dry leaves and other combustible debris).
· Consult a qualifi ed electrician to ensure correct branch circuit
conductor.
· For chain or hook suspension only.
· All electrical connections and wiring should be performed by a
qualifi ed electrician.
· This product must be installed in accordance with the applicable
installation code by a person familiar with the construction and
operation of the product and the hazards involved.
· Suitable for humid locations. Fixtures are designed to withstand
water ingress according to IP54 standards.
· Suitable for operation in ambient temperature not to exceed 40°C.
· To prevent electrical shock, turn off power before inspection, instal-
lation, or removal!
· This fi xture should not be installed in an enclosure or areas with
limited ventilation or high ambient temperatures.
TERMS AND CONDITIONS
This warranty only applies when the Product is: Properly wired and
installed, and operated and maintained in conditions, including
environmental conditions (temperature, humidity) in accordance with
the instructions contained in the User Manual. This warranty excludes
defects or damage caused by any primary side (line voltage) power
source problems including, but not limited to, unregulated power,
short circuits or lightning induced power surges, under/over voltage/
current conditions, operating outside specifi ed temperature range,
or storing the Product outside the specifi ed temperature range. The
warranty excludes defects resulting from acts of God, war, vandal-
ism, or civil disturbance. This warranty does not apply to any ab-
normal use or use in violation of any applicable standard, code or
instructions for use in installations including those contained in the
latest National Electrical Code (NEC), Standards for Safety of Un-
derwriters Laboratory, Inc. (UL), Standards for the American Na-
tional Standards Institute (ANSI) or, in Canada, the Canadian Stan-
dards Association (CSA). This warranty is void if:
• the fi xture is used for any other applications other than its intended use
• any modifi cation is made to the fi xture or its components
• the seals are intruded
• application voltage exceeds product voltage rating or installed by
an unqualifi ed electrical technician
• the fi xture operating conditions exceed those set at factory for
wattage and fan speed settings
· Do not drape, wrap, hang, or place anything on the ZELION HL300
fi xture.
· This fi xture should not be operated in any other orientation other
than as described in the installation portion of this manual.
· This fi xture is not intended for use in emergency exit signs or lighting.
· Risk of electrical shock: Do not disassemble product. No user
serviceable parts inside.
· Do not stare directly at the LED lights in fi xtures when turned on.
· Note: This product is not designed to be used with dimmers.
· If the power cable of fi xture is damaged, please call Customer
Service at 888-677-2627 or e-mail: docustsrv@sylvania.com.
ZELION
®
HL300 LED HORTICULTURE FIXTURES
LIMITED WARRANTY
OSRAM SYLVANIA Inc.
(“OSI”) provides a limited 2-year warranty
for ZELION
®
HL300 LED Horticulture Fixtures (the “Product”) sold
and used in North America. Subject to change without prior notice.
This limited 2-year warranty for workmanship and fi xture performance
begins one week after shipment date or the date the Product is
received by end user. OSI warrants to their authorized distributors
and subsequent purchasers that the Product listed below is free of
factory and workmanship defects, when delivered in new condition
and in its original packaging.
If the Product fails to operate during the warranty period, OSI will,
at its option, repair or replace the Product or components with the
same or similar Product or components, at no additional cost to end
user, and in accordance with the Terms and Conditions below. OSI
reserves the right to use products or component parts in the war-
ranty repair or replacement process that will be comparable in
function and performance to an original product or part, as deter-
mined by OSI in its sole discretion, and warranted for the remainder
of the original warranty period. LABOR IS NOT INCLUDED.
• operating temperature outside the specifi ed temperature range in
the User Manual
• storing the product outside the specifi ed temperature range in the
User manual
This warranty does not cover equipment, systems or components
from other manufacturers that the Purchaser uses in conjunction
with the Product. Any repair, alteration or modifi cation of the Prod-
uct, including replacement of Product components with components
of other manufacturers will void the warranty in its entirety.
WARRANTY ACTIVATION / PROCESS
To obtain coverage under this warranty, the end user must complete
an OSRAM warranty registration form online at www.osram-americas.
com/zelionhlwarranty within 30 days of purchase. In the event of an
allegedly defective Product, Purchaser shall contact Professional
and Industrial Applications, Specialty Lighting customer service at:
• Phone: 888-677-2627
• Fax: 855-543-1043
• Email: docustsrv@sylvania.com
If deemed necessary by OSI under the terms of this warranty, Pur-
chaser will receive a Return Material Authorization (RMA) number,
and shall promptly return the Product or Product component at the
Purchaser’s expense, to the address provided on the RMA. The RMA
must be included on both the packing slip of the Product or Product
component being returned and on the outside of the box. FAILURE
TO FOLLOW THIS PROCEDURE SHALL VOID THE WARRANTY.
ZELION HL LED Horticulture Fixture Description
OSRAM Product Number
ZELION HL300 Grow Light
61100
ZELION HL300 Grow White
61101
ZELION HL300 Sunlight
61098
