Page 7
2.0 UNPACKING, VISUAL INSPECTION AND INVENTORY
Review the contents. The following items should be included:
iConverter
5-Module Power Chassis
2 Rack mounting “L” brackets and 8 screws
1 Installed power supply: 8220-1 (AC) / 8225-1 (48VDC) / 8226-1 (24VDC)
2 Installed power supplies: 8220-2 (AC) / 8225-2 (DC) / 8226-2 (24VDC)
One power cord for each AC Power supply
User Manual
Warranty Card
Inspect equipment and immediately report any damage or discrepancies to Omnitron
at 949-250-6510. If equipment is damaged, do not apply power to the equipment.
3.0 SITE PREPARATION AND INSTALLATION
3.1 AC Powered Chassis Site Preparation
Power source should be available within 5 ft. of the chassis and installed per the
National Electrical Code, ANSI/NFPA-70.
This equipment requires 100-240VAC, 0.5Amp, 50/60Hz. Appropriate overloading
protection should be provided on all AC power source outlets utilized.
When rack-mounting this equipment, the rack should be appropriately earth-
grounded.
The operating temperature of this equipment is 0 to 50 degrees C. If installed in
a closed or multi-unit rack assembly, the operating ambient temperature of the
rack must not exceed the maximum rated 50 degrees C temperature.
Installation of the equipment should be such that the air flow in the front and
back of the unit is not compromised or restricted.
Installing this equipment into a rack in such a way as to make it unstable
may
cause injury or death
. Always make sure that the rack you are installing this
equipment into is properly secured, stable, balanced and designed to carry the
weight and weight distribution of this equipment.
Never use this equipment to carry any weight except its own. Never use it as a
shelf to support the weight of other equipment.
3.2 AC Powered Chassis Mounting
If rack mounting the chassis to a 19” standard rack, first attach the two enclosed
“L” shaped rack mounting brackets to the chassis using the enclosed screws.
If rack mounting, mount and attach the chassis (after the mounting brackets are
installed) to the rack using the appropriate rack mounting screws (not provided).
Attach the AC power cords (provided for each Power Supply) to the back of each
Power Supply and plug into the AC outlets. The fans should immediately begin to
run and any installed
iConverter
modules will illuminate the power LEDs.