Operating instructions EU 80
ÖSTLING Markiersysteme
6
7.0
Troubleshooting
7.1
Problem: No mark
Try the following:
•
Is the power cord plugged in ?
•
Are all the cables properly installed ?
•
Has a voltage been set ?
•
Is the circuit breaker (Pos. 7) on the back side in order ?
•
Is the marking head soaked with electrolyte ?
Please observe:
•
Electrolytic marking works for electrically conductive surfaces only.
•
Laquered, anodized, or other protected surfaces cannot be marked
electrolytically
7.2
Problem: Mark is unclear
•
Make sure that the stencil is clean.
•
Rinse the stencil with water to get rid of oxides.
•
Make sure that the surface to the product is clean. Clean off excess dirt or
oil with a dry cloth before you begin marking.
7.3
Problem: Black marks around the mark
The stencil has not been handled properly. It has been nicked and has a hole or is
torn in some other way. In order to correct the problem the best solution is to
replace the stencil. In an emergency, you may cover the holes with adhesive tape
until another stencil arrives.
Please call us when:
•
you experience technical difficulties.
•
you would like sample materials marked.
•
you would like more information regarding accessories such as
different marking heads, felt, electrolyte, conductive net, or you need
any other assistance.
•
you would like information about additional Östling products such as
pin marking, pad printing, lazer marking, or injet printing.
Summary of Contents for EU 80
Page 9: ...ÖSTLING Markiersysteme ...
