―E20―
7. WELDING PREPERATION (continued)
How to attach the hanging bracket
1.
Remove hexagon head bolt (M10X16) and Nut (M8) (3pieces) and remove the wire reel
hub from the reel bracket.
2. Disassemble the wire reel hub, replace hexagon head bolt (M8X16) (3 pieces) with hexagon head
bolt (M8X25) (3 pieces) of the hanging bracket accessory and reassemble the wire reel hub to its
original condition. When reassembling, pay attention to the order and direction of parts.
Observe the following precautions to prevent serious personal injury caused by fall of the
wire reel at the time of wire reel hub adjustment or hanging bracket installation.
●Mount the brake pad to the wire reel shaft as illustrated below
with care placed to the
mounting direction.
●Mount the brake disk to the wire reel shaft as illustrated below with care placed to the
mounting direction.
●In the event that the brake pad and the brake disk are used in wrong directions, the
hexagon head bolt comes loose due to rotations of the wire reel shaft and may fall
together with the wire reel shaft.
WARNING
Wire reel shaft
BRAKE DISK
Install the protrusion toward
the wire reel shaft side.
Wire reel shaft
BRAKE DISK
Brake pad
（
Install the felt surface toward the wire reel shaft side.
）
Hexagon head bolt
(M10X55)
Cap
Brake disk
（
Install the protrusion toward
the wire reel shaft side.
）
Wire reel shaft
Hexagon head bolt
(M8X25) (3 pieces)
(Hanging bracket accessory)
