―E24―
8. MAINTENANCE AND TROUBLESHOOTING (continued)
8.3 Welding wire other than aluminum
･
This wire feeder is for an aluminum wire. But mild steel wire is also applicable by exchanging parts.
･
Please rearrange to mild steel specification according to the wire to use. Please refer to the
following table for the correspondence of wire and the specification. Performance of wire feeder is
dependent on the brand etc. of the wire.
Applicable wire
Aluminum
specification
Aluminum
Brazing
Cupper
Mild steel
specification
Mild steel
Stainless steel
Inconel
･
In the welding with a special condition (aluminum wave pulse welding etc.) or special wires (Brazing,
copper, or Inconel, etc.), it is necessary to add the welding mode (option) to the welding power source.
･
For wire pressure adjustment of mild steel, stainless steel or brazing wire, refer to the section 7.2.
Rearrangement to mild steel specification
- Please exchange parts in the shaded portion of figure below to change specifications of this wire
feeder to steel specification.
Please detach first two rolls from above with middle gear, and exchange to pressure roll.
Please choose the one which is written “for steel” in remarks of 9.5(2)-(4).
- Please select the one that exists in the remarks column for steel about each part among the
optional accessories in clause 9.5 table (2)-(4).
- It is an item to which it drinks and the figure relates.
Refer to the section indicated in for details.
Pilot
Inlet guide
Feed roll 7.2
Center guide
Outlet guide 8.2
