BATTERY PRECAUTIONS
Follow these precautions when using a battery in this device:
1. Use only the size and type of battery specified.
2. Be sure to follow the correct polarity when installing the battery as indicated in the battery
compartment, a reserved battery may cause damage to the device.
3. Do
not
mix
different
types
of
batteries
together
(e.g:
Alkaline
and
Carbon-zinc)
or old batteries with fresh ones.
4. If the batteries in the device are consumed or the device is not to be used for a long period of time,
remove the batteries to prevent damage or injury from possible leakage.
5. Do not try to recharge the battery
as it is
not intended to be recharged; it can overheat and rupture.
( Follow
the
battery manufacturer’s instructions.)
6. The batteries shall not be exposed to excessive heat such as sunshin
e or fire
.
7. Clean the battery contacts and also those of the device prior to battery installation.
8. The remote control
is
supplied with a coin/button
cell battery. If the coin button cell battery is
swallowed, it can cause severe internal burns in
just 2 hours and can lead to death. Keep new
and used battery away from children. If the
Battery compartment does not close securely,
stop using the product and keep it away from
children. If you think batteries might have been
swallowed or placed any part of the body, seek
immediate medical attention.
CR2025
BATTERY INSTALLATION OF REMOTE CONTROL
Remote control operation range
●When there is an obstacle between the remote and the transmitter, the unit may not operate.
●When direct sunlight, an incandescent lamp, fluorescent lamp or any other strong light
shines on the REMOTE SENSOR of the unit, the operation of the remote may be unstable.
CAUTION
●Danger of explosion if the battery is incorrectly replaced.
●Replace only with the same or equivalent type.
9
Remove and discard the insulation film as illustrated on the right.
RELEASE
PUSH
OPEN
R2025
C
+
SN
Fig.1
Fig.2
Fig.3
First Time Use:
If the button cell is drained, replace it by a new one as below:
1. Push and slide out the battery holder as Fig.1 below.
2. Replace the button cell with a new CR2025 button cell as the polarity
markings on the rear of the Remote Control as Fig.2 below.
3. Close the battery hold as Fig.3 below.
9
