34
OticOn Agil
FITTING GUIDE
35
Power Adapters
When replacing the Receiver unit in a Power Mold using
a Receiver unit from the RITE Power shop kit:
1.
First remove the cover by very gently sliding the screw-
driver between the tube and the cover and applying a slight
upward pressure.
2.
Using the screwdriver, turn the locking plate counterclock-
wise by approx. 45 degrees. You will feel a slight release and
then remove the plate.
3.
Pull the Receiver unit out from the adaptor.
4.
Attach new Receiver gasket as shown on page 35.
5.
Follow instructions on page 31 to attach a new Receiver
to Mold.
1
2
3
changing from Mold to Dome
1.
Remove Receiver unit from Power Mold as shown
on page 33.
2.
Attach dome housing to the Receiver unit as shown.
First, insert the gasget on to the Receiver unit
as shown.
A new Receiver gasket seal must be used each time
the Receiver unit is attached to the shell.
Slide the Receiver gasket being carful not to roll it.
3.
Mount the transparent dome housing onto Receiver unit.
4.
Fix the Receiver unit by a locking plate.
5.
Place the transparent cover on the dome housing.
2
3
