34
Programming the channel set
Amigo R2 and R7 receivers can be programmed with any number (up to 29) of
channels that are available in the T20/T21 or the Wireless Receiver Programmer
(WRP).
To select or remove specific channels:
– Scroll to the desired channel using the
buttons
– Press Sync for each channel to select or remove
– Press to save and exit
– Press C (clear) to exit without saving changes
Always make sure that the R2 and R7 have enough channels to avoid
interference problems. But do avoid long channel lists, as this will
lengthen the time it takes to browse through the Automatic Channel
Seek function.
Also, note that the T20, T21 and WRP will always override any chan-
nel list and force the receiver to the channel currently being synchro-
nized. This new channel will not automatically be added to the list.
However, if you set the receiver to “Last Channel Used”, the device will
remember it until the channel is changed again. We recommend to use
the channel wizard before choosing the channels.
Receiver
Channel Set
Clear All
01 N01
02 N02
21 N61
42
Summary of Contents for Amigo R1
