50
OticOn chili
FITTInG GuIde
51
Pressing the Volume button for 2 seconds again activates
the hearing instrument microphones.
Note: the microphone state is memorized for each streaming
application by Streamer. Next time your client is watching
TV/making a phone call, the memorized microphone state will
be used.
The memorized microphone states are reset when the
“Connect” function is turned off.
Pairing
Prepare the mobile phones:
1.
Refer to the manual of the mobile phone for detailed
instruction on how to conduct the pairing (normally, it is
referred to as “find new Bluetooth device”). Set up the
mobile phone as instructed.
Note: For further information refer to the pairing guide located
on www.oticon.com
Prepare Streamer:
2.
Assure that the key lock is deactivated, i.e. the green
indicator on top of Streamer is visible.
3.
Press Streamer Connect button for 5 seconds until
the blue light starts flashing rapidly.
The two devices are now establishing a connection to each other.
Mobile phone handling:
4.
When the mobile phone has received Streamer information,
‘Streamer1.2 (or later)’ will appear in the display.
5.
Go to ‘Streamer 1.2 (or later)’ in the mobile phone display
and press select.
6.
You will now be prompted for a pincode: all Streamer pin-
codes are four zeros (0 0 0 0) – note, that just like for other
pincodes the 0’s most probably will appear as asterisks (*).
7.
Streamer and the mobile phone are now paired.
The pairing is done only once. If the phone is switched off or
Streamer is out of battery, the units will remained paired when
turned on again.
daily use
Phone calls with Streamer
Streamer must be within 10 meters of the mobile phone.
The connection must be active in order for Streamer and
mobile phone to work:
Press and hold the Connect button for 2 seconds until the blue
light turns on. After one minute the blue light will automati-
cally go into sleep mode (slowly fading on/off every 5 seconds)
to prolong battery lifetime.
Streamer and Mobile Phones
