INSTALLATION AND STARTUP
10
OI-6000-X-X-X-X-O OPS_GUIDE_REV 3.1
2.3.3
CONNECTING 4-20 MA OUTPUT
To utilize the 4-20 mA wired data output feature of the OI-6000, you will need to connect the signal cable
from your Otis Monitor sensor terminal block to the OI-6000 power terminal block located on the control
board. Refer to the following instructions for how to wire your device:
On the GEN II Model OI-6000 Detector:
1.
Feed the signal wire through the power hub and into the enclosure.
NOTICE
The power and signal wires may be conjoined as a 3-wire cable, incorporating the power (WHITE),
ground (BLACK), and signal (GREEN) wires all into one jacketed cable.
2.
Locate the power terminal block on the control board and complete the following:
a.
Connect the signal (GREEN) wire to the “4-20 mA” terminal.
On the Otis Monitor:
1.
Feed the signal wire through the power hub and into the enclosure.
2.
Locate the sensor terminal block on the control board and complete the following:
a.
Connect the signal (GREEN) wire to the “4-20 mA” terminal.
Summary of Contents for GEN II OI-6000
Page 1: ......
Page 2: ......
Page 4: ......
Page 28: ...INSTALLATION AND STARTUP 22 OI 6000 X X X X O OPS_GUIDE_REV 3 1...
