12
4. Transmitters and receivers
The chairlift has a separated receiver (PCB) built in for remote-control.
In case of a powered sliding hinge 2 extra remotes and 1 receiver is used for controlling the hinge in
and out.
Also an extra 1-channel transmitter (on the hinge) and 1-channel receiver (in the chairlift) is applied for
hinge-is-down command.
Before using the remote you have to teach them in and/or adjust the dipswitches.
The battery-voltages has to be connected, when you want to teach them in.
4.1 Teaching the 2-channel remotes into a 2-channel receiver
1.
Open the cover of the receiver-box.
2.
Operate the switch on the receiver once. (LED lights up).
3.
Operate within 30 seconds the up or down switch of the remote which should be programmed
in. The LED will go off.
(Battery on remote should be connected.)
4.
The up and down signal of the remote now will be ‘seen’ by the receiver.
5.
Repeat step 2 and 3 for the next remote.
(programming up to 16 remotes is possible.)
2-channel receiver
2-channel remote
•
For deleting the transmitters, keep switch on the receiver operated, until the LED dims. (5
seconds)
•
With the dipswitches, the send- and receive frequency can be changed.
•
The dipswitches on the remotes and the receiver have to be adjusted in the same position.
(always both on or both off)
4.2 Reverse logic up/down of the 2 channel receiver.
Depending on whether a rail is mounted at the left or right side of a staircase the logic (up/down) of the
remote might have to be reversed.
When dipswitch 9 = on, the remote-control is adjusted for right rail.
When dipswitch 9 = off, the remote-control is adjusted for left rail. (standard)
Dipswitches
LED
Switch
Switch
up/down
