15
5.2 Programming the chairlift
Start programming procedure when ‘potentiometer’ speed is set.
Programming procedure:
1 Switch
on
S
ervice.
2
Move the chairlift to the left by operating
L
eft (servicebox), until it stopped against the buffer
3 Release
L
eft
4 Switch
off
S
ervice.
5
Choose speed 1 or 2 (switch
1 2
)
speed should be set before programming procedure
6 Switch
on
T
each
7 Operate
R
ight (on servicebox) (the chairlift begins to move).
Keep Right operated till point 10.
8
If necessary, switch over the speed by operating switch
1 2
.
(Max of 35 times of switch over in speed possible)
9
If the chairlift has stopped against the other buffer, the system beeps 5 times.
10 Release
R
ight
11 Switch
off
T
each
12
Remove the connector from the service box if there are no additional charging points.
If an extra charge point has been installed on the rail, the chair can be programmed in for this.
Programming procedure for extra charge-point(s)
13 Switch
on
S
ervice
14
Move the chairlift to the extra charging point.
15
Park the chairlift exactly in the middle of the charging point.
16
Leave the system on
S
ervice and switch on
T
each mode, the system will beep once.
17
Switch off
T
each.
18 Switch
off
S
ervice.
19
Remove the plug from the service box.
If a second extra charging point has been installed, this can be programmed into the chairlift as well.
Repeat points
13
through
19
, the system will beep twice at point
16
. (3th charging-point 3 times...etc.)
In total 5 extra charging points/stoppoints can be added.
Extra charging-points can not be deleted.
When a incorrect charging-point has been programmed in, start at point 1.
You can choose for which control the chairlift should stop on the extra charging point(s)
Dipswitch 4
= on, the lift will stop when operated on by the remote-control.
Dipswitch 5
= on, the lift will stop when operated on the armrest.
Dipswitch 4 + 5 = on, the lift will stop when operated by the remote-control as well as on the armrest.
Activate alarm when controlled by remote
Alarm during movement when controlled by remote can activated or de-activated by controlling L+R
1sec on the servicebox. (Service and/ or Teach should be in off position)
This functionality is added in software version C40 or higher.
Only start programming the lift, when the lift is operating OK (without bypass-connector.)
The hinge should stand in the hinge out position.
Keep the transformer connected to the mains-voltage
