EN-5
8800-1209 Rev B.
4. Configure the sensor (Example SDI-12 sensor
–
Lufft WS400-UMB)
Select
“Measurements” tab in LinkComm
Select “Active” to activate measurement
“M1” and press “Sensor Template” for pre
-defined
sensor setups.
Filter “Lufft” as
a manufacturer
and “SDI
-
12”
as interface
, and select “WS400
-
UMB” as
a model;
Press “Yes” in the next prompt
“Configuration” can be left unchanged
Set
Schedule with time as “00:00:00”,
Averaging time “00:00:00” and Interval as
“00:15:
00
”
5. Setup logging interval and a transmission content
Continue in “Measurements” tab in LinkComm
Select “Log All” to log all measurements
into
memory
Telemetry1’s “Tx data content1” can be left at
“All Logged” to send data measured and
logged
after the last transmission.
Alarms are used to send immediate notifications when
sensor readings read a certain threshold; More details can
be found in SATLINK 3 operating manual
5.2
5.3
4.1
4.2
4.5
4.4
4.3
