9.4 Setting OTT ecoLog 800 (3G) operating parameters
How to set the OTT ecoLog 800 (3G) operating parameters
Click the "Connect" button (alternatively: menu "OTT ecoLog 800 (3G)",
"Connect" function)
➝
The operating program will read the current operating
parameters of the OTT ecoLog 800 (3G).
Setting operating parameters, refer to pages 30/31.
Optionally: "Set up cyclic data transmission via SMS" or "Set up cyclic data
transmission via GPRS(/3G)", refer to pages 28/29.
Set date/time: Accept the proposed PC date/time or individually set the
date/time using the "Set date/time" function, also refer to Chapter 15.
Please note:
The operating program automatically corrects any Daylight
Saving Time setting on the PC.
Click the "Save to device" button
➝
"Warning: Reset OTT ecoLog 800 (3G)
and delete data memory additionally?" Confirm by clicking "Yes" (recommend-
ed for initial installation and reinstallations).
Please note:
All measured values collected so far will be permanently lost!
Check the level of the measured value set (pressure sensor),
refer to Chapter 10.
Remove the OTT DuoLink/OTT IrDA-Link USB reading head.
Close the top cap/observation well cover.
Setting up the cyclic data transmission via SMS
1)
Enable the "SMS data transmission active" check box.
If necessary: Enable the "Authorize Roaming " and/or "Store GSM signal
strength" check boxes.
Click the "Settings modem" button
➝
The operating program starts a wizard
for setting all the necessary operating parameters.
Enter the receiver phone no. for the data SMS (phone number of a large
account or for a PC connected to a cellular modem).
Click the "Next" button.
If necessary: enter SIM PIN (4-digit) of the SIM card.
Click the "Next" button.
Set or enter the SMS-C phone no. of the network operator (phone number of
the SMS service center. By default, the SMS-C phone number is already saved
on the SIM card
➝
In this case, set to "SIM card".)
Click the "Next" button.
Select the mode of the SMS transmission.
Click the "Next" button.
Set the interval for transmitting the stored values.
Click the "Next" button.
Set the offset time for the transmission interval.
Click the "Exit" button.
Finally check the settings and correct as necessary.
Click the "OK" button.
1)
For further information, refer to online help.
28
Summary of Contents for ecoLog 800
Page 1: ...Operating instructions Groundwater Datalogger OTT ecoLog 800 OTT ecoLog 800 3G English...
Page 54: ......
Page 55: ......
