6.2 Calling up the OTT ecoN web interface
Note:
The Ethernet interface on the PC must be configured to automatically obtain
the required network settings (DHCP protocol).
Start any internet browser on the PC.
In the browser, enter one of the following:
– http://ecoN.ott/
– http://ecoN_serial number/
– http://192.168.77.1/
and press enter
➝
The home page of the OTT ecoN user interface opens (in
English).
Web interface menu structure
"Overview"
– Information about the OTT ecoN
– Information about the Xenon flash lamp
"Calibration"
– This function is reserved exclusively for OTT service personnel or specially
trained users; "Login" and "Password" required
"Data Logger"
– Simple, internal data logger;
the sample/storage interval is 30 seconds;
– "Clear" clears and formats the internal memory
– "Download" copies the measured values recorded in the selected period
("Start date" to "End date") to the PC
"Measurement"
– "Parameter": shows the measured results from the last measurement in a table
– "Measure now!": starts instantaneous value measurement
– "Settings": allows you to enter an offset value and scaling factor and to
calculate a sliding mean value over "n" measured values
– "Edit"
"Comment": enter any informative comments
"Automatic": activates/deactivates automatic measurement (must be activated
in combination with an OTT netDL or Sutron datalogger!)
"Interval [s]": sample/storage interval is 30 seconds;
"Pheripherals"
– RS-485 interface parameters; factory default setting: "Modbus RTU", "9600",
"none", "none", "1";
– "Address": Modbus address; factory default setting: "1"
Fig. 9: OTT ecoN user interface.
16
