20
Set date/time: adjust the proposed PC date/time or individually set date/time
using "Set date/time" (see also Chapter 13).
Caution:
The operating program automatically corrects any summer time PC
adjustments.
Click the "Connect" button
➝
"Warning: Reset the OTT Orpheus Mini and
delete data memory additionally?" Confirm with "Yes" (recommended for initial
installation and reinstallations).
Caution:
All measured values collected until now will be permanently lost!
Check the level of the measured value set (pressure sensor). See Chapter 8.
Remove the OTT DuoLink.
Close the top cap/observation well cover.
If required: Set up cyclical data transfer with SMS text message in
combination with an OTT ITC intelligent top cap
1)
Activate check box "Modem/ITC connected".
Activate check box "SMS data transmission active".
If necessary: Activate the "Authorize Roaming" check box and/or "Store GSM
signal strength".
Click on the "Settings ITC" button
➝
the operating program starts an Assistant
for setting all the necessary operating parameters.
Enter the receiver phone no. for the data SMS. (phone number of a large
account or for a PC with GSM modem.)
Click on the "Next" button.
If necessary: enter SIM PIN (4-digit) of the SIM card.
Click on the "Next" button.
Set or enter the SMS-C phone no. of the network operator. (Phone number of
the SMS service center. The SMS-C phone number is normally already saved
on the SIM card
➝
in this case, set to "SIM card".)
Click on the "Next" button.
Select the mode of SMS transmission.
Click on the "Next" button.
Set the interval for transmission of the storage values.
Click on the "Next" button.
Set the offset time for the transmission interval.
Click on the "Exit" button.
Check the settings afterwards and correct as necessary.
Click on the "OK" button.
If required: Set up cyclical data transfer using GPRS in combination
with an OTT ITC intelligent top cap
1)
Activate check box "Modem/ITC connected".
Activate check box "GPRS data transmission active".
If necessary: Activate the "Authorize Roaming" check box and/or "Store GSM
signal strength".
Click on the "Settings ITC" button
➝
the operating program opens a window
with several tabs for setting all the necessary operating parameters.
Make the required settings in the "General", "Operator", "FTP" and "Time sync."
tabs.
Caution:
The SIM PIN for the SIM card used should be deactivated!
Otherwise enter the SIM PIN for advanced operation in the "Modem/ITC" tab.
Click on the "OK" button.
1)
For further information, refer to the online help
Summary of Contents for Orpheus Mini
