5
SPRAY FUNCTION
1.
This function can be used at any time and does not affect the ironing temperature.
2.
Fill the water tank with water.
3.
Aim the nozzle toward the garment.
4.
Press the spray button.
5.
It may be necessary to press the spray button a few times to start this function.
STEAM FUNCTION
1.
Fill the water tank with water.
2.
Plug iron into the power point.
3.
Turn the temperature control in a clockwise direction to the
●●● (3-dot) setting. (Do not use the 1-
dot or 2-dot setting for steam ironing.) The indicator light will go on to indicate that the iron is
switched on.
4.
When the indicator light goes off, it indicates that the selected temperature has been reached.
5.
Turn the steam control knob to the required position. Steam will be emitted and you can start ironing.
6.
Stand the iron upright when taking short breaks during ironing.
7.
Once you have finished ironing, unplug the from the power point and allow to cool. Turn the iron
upside down and allow the water to drain out.
STEAM BURST FUNCTION
1.
This function provides an additional amount of steam to remove stubborn creases.
2.
Fill the water tank with water.
3.
Plug iron into the power point.
4.
Set the temperature control to the MAX position to prevent water from leaking from the soleplate if
the temperature is low. The indicator light will go on to indicate that the iron is
switched on.
5.
The indicator light switches off when the required temperature is reached.
6.
Press the steam burst button once.
7.
It may be necessary to press the steam burst button a few times to activate the function.
8.
Steam will penetrate the fabric to remove creases.
9.
Wait a few seconds before pressing the steam burst button again to remove stubborn wrinkles.
10. For optimum steam quality, do not use the steam burst function more than three times after the
indicator light goes off.
ENGLISH
