5.2 Storage
5.2.1 Storage during daily use
The product should always be stored so it is protected against external influences.
5.2.2 Storage during extended disuse
The product must be stored in a dry place. Specific information for extended storage: see page 35.
It is not necessary to disassemble the product.
Maintain sufficient clearance from sources of heat. If the product is parked for an extended period of time or the
tyres overheat (e.g. in the vicinity of radiators or in case of exposure to strong sunlight behind glass), the tyres may
become permanently deformed.
During extended storage, the knee lever wheel lock on wheelchairs with PU tyres (= tubeless tyres) must be
released since tyre deformation may otherwise result.
6 Preparing the product for use
6.1 Assembly
CAUTION
Failure to verify readiness for use before putting into operation
Tipping, falling due to incorrect adjustment or installation
►
Before you start using the wheelchair for the first time, check the chosen wheelchair settings with the support
of authorised personnel.
►
After every assembly, check for proper mounting of the drive wheels. The drive wheels must be securely
locked in the quick-release axle housings.
►
Pay particular attention to the stability against tipping and free running of the drive wheels.
►
Check the tyre pressure. The correct tyre pressure is printed on the sidewall. Ensure that the pressure is the
same in both tyres.
The wheelchair is preassembled on delivery:
•
Basketball version, Basketball ULW version (ultra lightweight; see fig. 4)
•
Rugby version (see fig. 5, the "Rugby Offense" version is illustrated)
It takes just a few simple steps to prepare the wheelchair for use:
1) Attach the drive wheels to the quick-release axle mountings (see page 24).
2)
If necessary:
Fit the seat cushion. The seat cushion is secured against sliding by being pressed on to the
hook-and-loop fastener (see page 21).
4
5
13
Invader 480S26=20000_K
Preparing the product for use
Summary of Contents for 480S26 20000 K
Page 1: ...Instructions for use 3 Invader 480S26 20000_K...
Page 2: ...2 Invader 480S26 20000_K...
Page 37: ...37 Invader 480S26 20000_K...
Page 38: ...Invader 480S26 20000_K 38...
