Service work
490E75=0_C
Ottobock | 29
3) Insert the 2 tilt module screws with nuts and hand-tighten them (see Fig. 35, item 2).
4) Connect the tilt module to the bus system (see Fig. 35, item 1).
5) Connect the distributor relay to the seat tilt actuator and the seat module (see Fig. 34, item 1; see Fig. 36).
zC@>C<II@G<NNDBIH@IO?@K@I?NJIOC@M@H<DIDIB>JIuBPM<ODJIJAOC@RC@@G>C<DM
N@@Page¿ÆA{{
6) Attach the seat module cover (see Page 25 f.).
34
35
Removing/installing the combined memory function
The combined memory function encompasses a tilt module, ASM module and two distributor relays. The individual
components are respectively removed and installed the same way as for the single memory function.
Observe the following instructions:
• Attach the tilt module to the module carrier of the seat module (see Fig. 33, item 4). It is used for the back support
angle adjustment memory function.
• Attach the ASM module underneath the seat plate (see Fig. 35; item 3). It is used for the seat tilt memory function.
• Connect both distributor relays to the respective actuator and the seat module.
• The channel assignment depends on the remaining configuration of the wheelchair (see Page 29 f.).
Channel assignment (single memory function)
With a single memory function, the channels are assigned as follows by default:
• Configuration without chin control: memory function on channel 6
• Configuration with chin control and without power leg supports: memory function on channel 4
• Other configurations: memory function only by request to Ottobock as custom fabrication
Channel assignment (combined memory function)
With a combined memory function, the default channel assignment is as follows:
• Configuration without power leg supports: memory functions on channels 4 and 5
• Configuration without chin control and without seat height adjustment: memory functions on channels 3 and 6
• Other configurations: memory function only by request to Ottobock as custom fabrication
Summary of Contents for 490E75 Series
