Ottobock recommends the use of structural components with a dia
meter of 34 mm when elevated loads are expected (e.g. for a transtibi
al prosthesis).
2.3 Environmental conditions
Storage and transport
Temperature range –20 °C to +60 °C (–4 °F to +140 °F), relative
humidity 20 % to 90 %, no mechanical vibrations or impacts
Allowable environmental conditions
Temperature range:
–10 °C to +45 °C (14 °F to 113 °F)
Moisture:
relative humidity: 20% to 90%, non-condensing
Unacceptable environmental conditions
Chemicals/liquids:
fresh water, salt water, perspiration, urine,
acids, soapsuds, chlorine water
Solids:
dust, sand, highly hygroscopic particles (e. g. talcum)
2.4 Lifetime
This product was tested by the manufacturer with 3 million load
cycles. Depending on the user’s activity level, this corresponds to a
maximum lifetime of 5 years.
3 Safety
3.1 Explanation of warning symbols
CAUTION
Warning regarding possible risks of accident or
injury.
NOTICE
Warning regarding possible technical damage.
3.2 General safety instructions
Risk of injury and risk of product damage
CAUTION!
7
►
Comply with the product's field of application and do not expose
it to excessive strain (see page 6).
►
Note the combination possibilities/combination exclusions in the
instructions for use of the products.
►
Do not expose the product to prohibited environmental condi
tions.
►
Check the product for damage if it has been exposed to prohib
ited environmental conditions.
►
Do not use the product if it is damaged or in a questionable con
dition. Take suitable measures (e.g. cleaning, repair, replace
ment, inspection by the manufacturer or a specialist workshop).
►
Observe the maximum lifetime of the product.
►
To prevent mechanical damage, use caution when working with
the product.
►
If you suspect the product is damaged, check it for proper func
tion and readiness for use.
►
Do not use the product if its functionality is restricted. Take suit
able measures (e.g. cleaning, repair, replacement, inspection by
the manufacturer or a specialist workshop).
Signs of changes in or loss of functionality during use
Among other factors, changes in functionality can be indicated by an
altered gait pattern, a change in the positioning of the prosthetic com
ponents relative to each other and by the development of noises.
4 Scope of delivery
Quant
ity
Designation
Reference number
1
Instructions for use
–
1
Adapter
–
1
Cap screw
501Z2=M4x22
2
Clamping screw
501Z16
4
Set screw
506G3=M8x16
1
Set screw
506G3=M5x8
Summary of Contents for 4R103
