03/2010
B500 | B500-S
Page 103
Delivery and Putting into Operation
fig. 3.1 Anti-tipper B500
The tool kit consists of:
– 1 set of Allen wrenches, sizes 3 mm, 4 mm, 5 mm,
6 mm
– 1 open-end wrench, size 13 mm
6.2 Putting into Operation
Prior to putting the power wheelchair into operation, the
completeness (see fig. 3) and function of all its compo-
nents must be checked. Before the power wheelchair
can be switched on, the 80 A fuse must be inserted into
the fuse holder at the rear end of the battery case (see
fig. 4).
To do so, remove the fuse from the protective cover on
the control panel, open the cap of the safety holder and
insert the fuse.
Make sure that the fuse is pressed into the centre of the
spring contacts and that it does not lie at an angle. Close
the cap until you feel it snap back into place.
fig. 4
fuse holder
1 Cap, open
2 Fuse, inserted
3 Fuse holder
