03/2010
B500 | B500-S
Page 140
Options
With the Recaro LT backrest, the lateral guide in the lum-
bar section can be individually adjusted by turning the
hand wheel. Turning the wheel to the front brings the two
lateral guides closer to each other evenly. Turning the
wheel to the rear adjusts the two lateral guides away
from each other.
Seat Bottom
The seat bottoms X and W have a telescoping padding
section at the front. The lever used to adjust the padding
section is located below the seat bottom. Pull the lever
up to shift the padding section into the desired position.
The padding section locks in place as soon as the adjust-
ment lever is released. The adjustment lever must audi-
bly lock in place and return to its initial position.
Headrest
A fixed height of the headrest can be set; the inclination
is adjustable.
A second person is needed to remove the headrest. The
pressure points must be detected under the cover by feel
and be pressed simultaneously. Now the second person
can pull the headrest out upwards.
removing the recaro® Seat from the chassis
r
Pull the release strap beneath the front part of the
seat.
r
Loosen the right and left bolt that serve to lock the
seat to the frame.
r
To release the posterior seat attachment from the
retainer bushings, slightly tilt the seat to the rear and
slide back a little.
r
Remove the Recaro® seat.
Attaching the recaro® Seat to the chassis
ATTEnTIOn !
Risk of injury if lock does not engage!
When mounting the Recaro® seat, the seat
adapter must be securely attached to the
retainer bushings. The anterior locking bolts
must have snapped into place up to the key
ring.
r
Place the posterior edge of the Recaro® seat on the
end of the seat frame.
r
Slide the seat forward until the posterior seat attach-
ment hangs in the retainer bushings.
r
Tilt the seat to the front until the locking bolts engage
with the seat frame.
