11.1 Liability
The manufacturer will only assume liability if the product is used in accordance with the descriptions and instruc
tions provided in this document. The manufacturer will not assume liability for damage caused by disregard of this
document, particularly due to improper use or unauthorised modification of the product.
11.2 CE Conformity
This product meets the requirements of the European Directive 93/42/EEC for medical devices. This product has
been classified as a class I device according to the classification criteria outlined in Annex IX of the directive. The
declaration of conformity was therefore created by the manufacturer with sole responsibility according to Annex VII
of the directive.
The product meets the requirements under the RoHS Directive 2011/65/EU of the European Parliament and of the
Council of 8 June 2011 on the restriction of the use of certain hazardous substances in electrical and electronic
equipment.
11.3 Warranty
Further information on the warranty terms and conditions can be obtained from the qualified personnel that has fit
ted this product or the manufacturer's service (see inside back cover for addresses).
11.4 Service Life
Expected service life:
5 years.
The design, manufacturing and requirements for the intended use of the product are based on the expected ser
vice life. These also include the requirements for maintenance, ensuring effectiveness and the safety of the
product.
Using the product beyond the specified expected service life leads to increased residual risk and should only take
place subject to the due diligence and deliberations of qualified personnel.
If the service life is reached, the user or a responsible attendant should contact the qualified personnel who fitted
the product or the manufacturer's servicing department (see inside rear cover or back page for address). Here the
user can obtain information about known risks and the current options for refurbishing the product.
11.5 Trademarks
All product names mentioned in this document are subject without restriction to the respective applicable trade
mark laws and are the property of the respective owners.
All brands, trade names or company names may be registered trademarks and are the property of the respective
owners.
Should trademarks used in this document fail to be explicitly identified as such, this does not justify the conclusion
that the denotation in question is free of third-party rights.
12 Technical data
General information
Application class (in compliance with DIN
EN 12184)
Class C
Dimensions and weights
Standard seat
Contour seat
Recaro
®
seat*
Seat depth
380 – 500 mm
360 – 480 mm
380 – 560 mm
Seat width
380 – 560 mm
380 – 560 mm
450 – 480 mm
Seat height
470 mm with front-
wheel drive
530 mm with rear-
wheel drive
approx.
520 mm;
approx. 570 mm
Lower leg length
250 – 540 mm
280 – 540 mm
Dimensions and weights
Seat height adjustment
+ 300 mm or +400 mm (depending on version)
Armrest height
225 – 350 mm
Armrest length
260 mm
Back height (standard seat)
450/500/550 mm
Back angle
Manually, in 10° increments: -9°/1°/11°/21° or 0°/10°/20°/30°
Ottobock | 65
C2000
Technical data
Summary of Contents for C2000
Page 1: ...C2000 Instructions for use 3 ...
Page 69: ...Ottobock 69 C2000 ...
Page 70: ...C2000 70 Ottobock ...
