Use
Invader Pointer
16 | Ottobock
7.6.1.1 Adjusting the lower leg length and the plate angle
After adapting the seat height and the seat inclination, the lower leg length and the plate angle can be adjusted on
the legrest� The legrest angle setting should be chosen so that the ankle is in a relaxed, comfortable position�
1) Loosen the screw connections on both clamp brackets of the legrest (see Fig� 15)�
2) Pivot the legrest to the desired height and desired angle�
3) Firmly tighten the screw connections on both clamp brackets of the legrest (see Fig� 15)�
15
7.6.1.2 Adjusting the footplate position
The footplate can be moved in 3 levels to the front or rear�
1) Loosen and remove the 4 screw connections on the footplate (see Fig� 16, item 1)�
2) Move the footplate to the desired position on one of the 3 levels�
INFORMATION: If the legrest is equipped with lateral heel blocks, the adjustment range of the footplate
may be restricted.
3) Insert the 4 screw connections into the appropriate slots on the footplate and firmly tighten them (see Fig� 16)�
16
17
Expanding the adjustment range
If a larger adjustment range is required, the footplate can be turned by 180°�
1) Loosen the screw connections on both clamp brackets of the legrest (see Fig� 15)�
2) Pivot the legrest to the top position�
3) Move the footplate with the axle to the side and out of the clamp brackets (see Fig� 17)�
4) Insert the footplate with the axle turned 180° into both clamp brackets and centre it�
5) Pivot the legrest to the desired height and desired angle�
6) Firmly tighten the screw connections on both clamp brackets of the legrest�
