64
65
6.15 Installing and adjusting the side thoracic support
INFORMATION
The side thoracic supports may only be adjusted by appropriately trained and qualified personnel. Make sure that
the seat belt is applied.
Installing the thoracic support
1) Install the thoracic support on the back support tube using the clamp bracket (see fig. 66, see fig. 67, item 1).
2) Align the clamp bracket in height and to the front before tightening. Firmly tighten the Allen head screws.
Adjusting the thoracic support
1)
If necessary:
Loosen the clamp bracket and adjust the angle and height of the pad (see fig. 67, item 1/2).
2) Slightly loosen the mounting screws on the ball joint head and adjust the angle of the pad (see fig. 67, item 3).
3) If necessary, the curve of the mounting rod can also be changed using a bending tool (711S6, not included in
the scope of delivery).
66
67
6.16 Installing the tray
The tray slides onto the arm supports.
7 Delivery
7.1 Final inspection
A final check must be carried out before the wheelchair can be handed over:
•
Are the drive wheels correctly positioned?
•
Can the quick-release axles rotate freely?
•
For pneumatic tyres:
Is the tyre pressure correct (see tyre sidewall for information)?
•
Only after adjustment: Have the brakes (wheel locks) been adjusted correctly?
•
Only after adjustments: Has the respective caster journal angle been adjusted vertically?
•
Only after adjustments: Has the anti-tipper been adjusted correctly?
28
Delivery
Start M2S, Start M2
