7 Delivery
7.1 Final inspection
A final check must be carried out before the wheelchair can be handed over:
•
Are the drive wheels correctly positioned?
•
Can the quick-release axles rotate freely?
•
For pneumatic tyres:
Is the tyre pressure correct (see tyre sidewall for information)?
•
Only after adjustment: Have the brakes (wheel locks) been adjusted correctly?
•
Only after adjustments: Has the respective caster journal angle been adjusted vertically?
•
Only after adjustments: Has the anti-tipper been adjusted correctly?
7.2 Transport to the customer
The wheelchair should be transported to the user in disassembled state using the outer packaging.
7.3 Handing over the product
The following steps must be performed for the safe delivery of the product:
•
Conduct a sitting test with the user of the product. Pay special attention to proper positioning according to
medical considerations.
•
The user and any attendants must be instructed in the safe use of the product. In particular, the enclosed
instructions for use (user) are to be used.
•
The instructions for use (user) must be issued to the user/attendant during handover of the wheelchair.
8 Maintenance and repair
The manufacturer recommends regular maintenance of the product every
12 months
.
More information on cleaning, disinfection, maintenance and repair can be found in the instructions for use (user).
The service manual contains detailed information on repairs.
9 Disposal
9.1 Disposal information
All components of the product must be disposed of properly in accordance with the respective national environ
mental regulations.
9.2 Information on re-use
CAUTION
Used seat padding
Functional and/or hygienic risks due to re-use
►
Replace the seat padding if the wheelchair is to be re-used.
The product is suitable for re-use.
Similar to second-hand machines or vehicles, products that are being re-used are subject to increased strain. Fea
tures and functions must not change in a way that could impair the safety of users or third parties during the period
of use.
The relevant product must be thoroughly cleaned and disinfected before re-use. Then have the product inspected
with respect to its condition, wear and tear, and damage by authorised, qualified personnel. Worn and damaged
parts as well as components that do not fit or are unsuitable for the user must be replaced.
Detailed information on replacing components as well as information on the required tools and the prescribed ser
vice intervals can be found in the service manual.
10 Legal information
All legal conditions are subject to the respective national laws of the country of use and may vary accordingly.
10.1 Liability
The manufacturer will only assume liability if the product is used in accordance with the descriptions and instruc
tions provided in this document. The manufacturer will not assume liability for damage caused by disregarding the
information in this document, particularly due to improper use or unauthorised modification of the product.
24
Delivery
Start M4 XXL, Start M6 Junior
