CAUTION:
Uses 3 x AA (1.5V) size batteries – Included
Do not mix old and new batteries. Do not mix alkaline, standard
(carbon-zinc), or rechargeable (nickel-cadmium) batteries.
Do not dispose of this product in fire. Batteries inside product
may explode or leak.
(If the door falls off,
please assemble it
as Fig A.)
Step 2: Push the axle to the hole.
Step 1: Put the axle into the hole.
Pull down the hitch to connect the car.
Pull to open the door.
Car hitch connects with Mane Attraction
Horse Trailer
TM
(sold separately).
Car hitch connects with R.V. Seeing
You Camper
TM
(sold separately).
Fig A
How to assemble back door:
How to attach R.V. Seeing You Camper
™
and Mane Attraction Horse Trailer
™
:
Pull down
to open
Pull to
open
Print 1 solid color PMS 676 C
Size A4: 11.69” x 8.27”
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following
two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device. Under Industry Canada regulations, this radio
transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter
by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be
so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful
communication.
Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut fonctionner avec une antenne
d'un type et d'un gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie Canada. Dans le but de réduire les
risques de brouillage radioélectrique à l'intention des autres utilisateurs, il faut choisir le type d'antenne et son gain de
sorte que la puissance isotrope rayonn ée équivalente (p.i.r.e.) ne dépasse pas l'intensité nécessaire à l'établissement
d'une communication satisfaisante. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autoris é e aux deux conditions suivantes : (1) l'appareil ne doit
pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to whichthe receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to thefollowing two conditions : (1) this device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
thatmay cause undesired operation. Shielded cables must be used with this unit to ensure compliance with the ClassB
FCC limits. FCC RF Radiation Exposure Statement Caution: To maintain compliance with the FCC’s RF exposure
guidelines, place the product at least 20cm from nearby persons. The device must not be co-located or operating in
conjunction with any other antenna or transmitter. “This device complies with FCC radiation exposure limits set forth
for general population (uncontrolled exposure). This device must not be collocated or operating in conjunction with
any other antenna or transmitter.”
CAN ICES-3 (B)/NMB-3(B)
