Accessories
Step 1: Fix the heater with the bracket that provided by using the 4pcs of M6*10mm Screws and knobs
tightly.
Step 2: Fix the bracket on the wall by using the 4PCS M6*50mm screws that provided tightly.
Step 3: Adjust reflector on heater required beam direction. Typically, this will be a declination of about
30°- 45°from horizontal. Tighten knobs on end caps once direction has been fixed.
Only use the halogen heater on a firm solid vertical wall where the Mounting Bar is in
contact with the wall.
www.outtrade.nl
251225743_2.doc
