1.
Mount the heater outside or in a large open area and well away from any obstructions such as
branches or where the heater is near any objects that can be affected by heat, such as furni-
ture, curtains or other inflammable objects (minimum distance 1 meter).
2.
Do not use near bath tubs, wash areas or swimming pools.
3.
Do not use in unventilated areas
4.
Do not use where gas, petrol, paint or other inflammable goods are stored.
5.
Do not push any items through, obstruct or cover the grill of the heater head.
6.
Do not position immediately above or below an electrical socket.
7.
Do not move when connected to an electrical supply and always wait for the patio heater to
cool down before storing away.
8.
Do not touch the heater head when in use.
9.
Do not leave turned on and unattended especially when children and or animals are in the vi-
cinity.
10.
The indication of the different positions of switches shall be visible from a distance of 1M.
11.
The Marking concerning covering shall be visible after the heater has been installed. It shall
not be placed on the back of heaters.
12.
The unit must be placed with the clearance of 180cm to the floor and 30cm to the ceiling.
13.
The unit must be correctly installed according to the instructions. Make sure the head is at
least 1.8m from the floor.
14.
The unit must be securely placed on a vertical and flat wall.
15.
The unit is at high temperature during operation. It keeps hot for a period after shut down.
Potential danger would occur when touching it during this period.
16.
Don’t place the unit closed to curtain and/or other flammable objects. Otherwise there will be
a danger of catching fire.
17.
Don’t cover the unit with anything during operation or a short time after it’s shut down.
18.
Don’t wrap the power supply cord on the unit.
19.
The unit must be handled with care, and avoid vibration or hitting.
20.
The unit must be securely grounded during operation.
21.
If the unit gets damaged, it must be repaired by professional electricians.
22.
When the power supply cord is damaged, it must be replaced by authorized agent or other
professional people to avoid danger.
23.
The unit must not be positioned under a socket.
24.
When assembling, keep clear from any board or flammable material.
25.
The unit must be supervised by adults if it’s used by a child.
26.
It is not safe to install the unit by a swimming pool, in a bathroom or shower area.
27.
It is not safe to use on a building site, greenhouse, barn or stable where there’s flammable
dust.
28.
The head of the unit is at high temperature during operation. Unplug the unit and wait till it
cools before cleaning.
29.
Don’t use this unit in place where causticity or volatile air exists, i.e. dust, steam, gas, etc.
30.
Don’t use this unit as a cloth drier or towel drier.
31.
Don’t use this unit as a sauna heater.
32.
Don’t use this unit as a room heater.
33.
Don’t use this unit in place of animal propagating and rising.
34.
Don’t immerse this unit into water for cleaning.
35.
The unit should be plugged in a socket, which is easily visible and reachable.
36.
Two Dark points may exist on the surface of the heating elements during the first few minutes
after it is turned on. This is normal, and will not affect the performance of the unit.
37.
This appliance is not intended for use by persons (including children) with reduced physical.
Sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety.
38.
Children should be supervised to ensure that they do not play with the appliance.
Operation
Connect the power cable to a 230V, 13 amp supply that is located in a safe, dry area.
•
The
Pull-Off Switch
is used to control the power of the appliance.
•
Once the power is on, the
Pressing Switch
on the heater is used to control the two heat
settings. (I) for1200W
II for2400W The 0 position is off.
•
The
Remote control
is also used to control the two heat settings. (I)
www.outtrade.nl
251225743_2.doc
