- 2 -
Installation:
Install the AutoMate interface to the rate controller with the following steps.
1. Disconnect the control cable
from the back of your rate
controller.
Fig. 1: Rate Controller
2. Connect the Interface Cable
(
A
) to your rate controller.
3. Connect the Interface Cable
(
A
) to your sprayer rate
controller cable.
Fig. 2: AutoMate Connected
4. Connect the Power and
Control connectors of the
Interface Cable (
A
) to the
AutoMate console.
5. If you have a rate controller
that does not have a master
switch, you will need to
connect the orange/white
wire of the interface cable
(
A
) to the master switch on
the sprayer.
Fig. 3: AutoMate console
Orange/White
Wire
Control Cable
Interface Cable (
A
)
Control Cable
