5
Installation Tips
• Never use less than the minimum recommended number and type of fasteners when installing
the FLEXware Mounting Plates.
• Each FX weighs in excess of 50 lbs and is often more easily installed by two people rather
than one.
• Be sure the DC enclosure is secured to the FLEXware Mounting Plate before attaching the
MX Charge Controller to it.
• Installation of each enclosure and breakers is normally easier by removing the breaker brackets
first. Do not remove any breaker knockouts from these brackets without referring to the chosen
AC IOB kits and DC breaker selections first.
• It is also easier if all conduit knockouts are removed before mounting the enclosures.
Mounting and Installation
FLEXware 1000 is designed for mounting on the FLEXware Mounting Plate (FW-MP). Although the
components can be secured to other surfaces, the FW-MP is an engineered platform designed
for the FLEXware 1000 installation. This manual illustrates such an installation.
OutBack does not
endorse other installation methods and therefore cannot recommend fasteners or other means of
attachment due to the variety of installations possible in the field.
Please see the FLEXware Mounting Plate Instructions for further information.
In addition to installing the AC and DC chassis, a typical installation includes four FX Series Invert-
er/Chargers, one or more MX Charge Controllers, a HUB Communications Manager, and AC and
DC Conduit Adapters. The installation of these components is also displayed in these instructions.
T
Slot indicates this is the top edge of the FW-MP
Figure 3:
FLEXware Mounting Plate
The MX Charge Controller attaches
to the chassis using three #10 X 3/8”
sheet metal screws included in the
hardware kit. Two are inserted from
inside the MX and the third through
the hanger on the top of the MX.
MX Knockouts
Figure 13:
MX Charge Controller 1” knockouts
Charge
Controller
knockouts
14
1000 Manual.indd, Spread 8 of 12 - Pages (8, 17) 11/22/06 11:07 AM
