www.outcastboats.com
~ 800-966-0976
1. Find the seat location that best
suits you.
2. Connect the 2 front swivel snaps to
the cargo loops.
3. Skip 2 cargo loops.
4. Connect the 2 back swivel snaps to the cargo loops.
5. Pull the seat straps tight.
6. The seat stays fully in place when you sit in it.
Set Up - Step 2 - Seat Installation:
Items Needed
:
1 - OSG Commander on soft pressure
1 - Seat
Set Up - Step 3 - Oar Installation:
Items Needed
:
1 - OSG Commander on soft pressure
2 - Oar Blades
2 - Oar Shafts
1. Snap the oar blade into the oar shaft.
2. Slid oar onto bolt peg with the blade curving into the boat.
3. Screw the oar keeper onto the bolt. Be sure the string
wraps on the outside of the oar.
4. Repeat steps for other oar.
Set Up - Step 4 - Top off OSG Commander to Full Pressure:
Items Needed
:
1 - OSG Commander on soft pressure
1 - Vinyl Tube Valve Adapter
1 - Summit 2 Valve Adapter
1 - Pump (not included)
1. Use a hand pump to top off OSG
Commander to full pressure.
2. Connect the clear vinyl valve adapter to the
pump hose and to the gray Summit 2 valve
adapter.
3. Insert the Summit 2 valve adapter into the valve on the boat. A 1/4 turn to the right will lock the adapter to the valve.
4. Inflate the chamber to 2.5 psi, full pressure. A good rule for gauging the proper pressure is to push with your thumb at
the center of the tube, when you can deflect about a half an inch from the top plane of the tube, it will be close to 2.5
psi.
5. DO NOT over inflate the kayak.
6. Cover valves with dust cap.
Set Up - Step 5 - LCS Stripping Apron Installation:
Items Needed
:
1 - OSG Commander to full pressure
1 - LCS Stripping Apron
1. Secure left side of the apron stays into the stay pockets.
2. Once seated in the OSG Commander Secure the right side of apron.
3. Adjust apron to desired height.
Note: The LCS Stripping apron is designed to come out of stay pockets incase the boat becomes
capsized.
