14
Operational Procedures
Starting a fire in the furnace (
continued)
STEP 4 : Make sure the blower switch is in the off position. Light a piece of paper
on fire and throw it to the back of the furnace. Immediately turn the fan switch to the
on position for 3 seconds and then turn off. This ensures that the fire will make con-
tact with your starter fuel. Once the starter fuel has begun to burn, close the door
and immediately turn on the blower switch.
Lighting fire
Starter fuel igniting
Fan pushing fire into kindling
(
Shown with the door open for instruc-
tional purposes only!
)
!
Never lean or reach into the firebox for any reason!
Start your fire with paper and kindling only! NEVER use
gasoline, kerosene, charcoal lighter fluid or any other similar
liquid to start or freshen up a fire!
!
Always open door slowly
!
Burn dry seasoned wood only.
Store wood in dry covered area
outside of the require clearances
and out of the way of cleaning
and fueling the furnace. Estab-
lish a safe routine for fuel storage
and loading.
Summary of Contents for Elite Heat 4868P
Page 26: ...26 Wiring Diagram ...